Sparks Will Fly

The weekend is here and I have an extra day to work on the car. I arrived at Mustang Maniac and found the guys preparing some cars for collection by their owners. I had a chat with Adam to see what needed to be done on my car first. The last bit of scraping then maybe a change if I managed to get it all done. I cleaned up the front engine bay panel and found some hidden numbers marked on it under the paint. I had a conversation with Adam about them and it turns out these are the original factory markings. This is good on two accounts; The first being that the front panel is original and has not been replaced due to an accident. The second is that the markings match up to the fender, secret numbers and the door plate. I have taken some pictures of the original markings during the cleaning and then I have gone over them in a colour to make them stand out a little better. The top set is actually 5A but it looks like the 6 prefix has rubbed off. These numbers which are the model type the other numbers are options for the car, interior colour – black etc. The third picture is after the clean up. I wasn’t sure if the numbers would still be there after the final cleaning up. No matter what I did to the marks they stayed there. Impressive stuff for forty eight year old grease proof marker.

I cleaned up the rear chassis legs to the point where they will be replaced. Then it was the right side wheel Arch for a clean up. Same procedures again, stripper, scrub, scrape and repeat. What was left is a little surface rust but it’s basically solid. There is a whole that needs to be patched up though, in the chassis leg that has been uncovered as a result of the clean up.

After that it was time for a change, the poor welding on the floor plan is to be ground down to see if there are any holes that are in need of re-welding. Adam was on the case to start the process to see the quality of the welding. The set of pictures here show just how bad this batch of welding is.

The grinding wheel started and the slow process to gently grind down the high spots without damaging the panels. The sparks were flying alright. The initial quick test patch was completed to his satisfaction. I was shown the technique ready for me to take over after putting on my new welding gloves, ear plugs & safety specs. I will post the pictures once I have completed some of the work. It made for a nice change and things look like they are starting to step up a gear.

I can’t wait for more of the same, but when somebody does it so easily and makes it look simple, it’s difficult to follow in those footsteps. I am a fast learner and I will step up my game.


Share my Content

4 thoughts on “Sparks Will Fly

  1. Just want to let you know that your last 3 posts did not show up in my Reader. This is a big problem that WP sometimes has. I’m glad stopped by to see why you’ve been so quiet lately…

  2. I’m not sure if I feel sorry for you or envy you! I remember when I did floor pans on a 69 mach, and I had fun for about….not too long!! I’m guessing was the fact that my customer got me some aftermarket pans that really didn’t fit well. Lots and lots of welding….lots and lots of grinding. I did finish it off inside with some sprayable seam sealer which also helped cut back road noise. For once my customer came up with a splendid idea!! Looking good!

    1. I think it’s definitely feel sorry as its hard work. But it’s rewarding when u see shiny metal underneath it all. The welding on the floor pans is disgraceful to say the least!

Leave a Reply to LaVagabondeCancel reply