Over the last few weeks I have been having a few trips down to Mustang Maniac where they have been developing a part which is aimed at people like me. It’s obviously going to be a mustang part, but more for my own pleasure of driving the car.
These heavy gauge steel bars have been black zinc plated for longevity and a good base for some proper coloured paint. A touch of déjà vu transporting me back ten odd years to when my car was being restored; Adam said ‘Take these back with you and satin spray them for your homework’, so that’s exactly what I did the next afternoon.
First of all was the prep to make sure a good paint bond where I cleaned the bars with a little isopropanol alcohol to remove any greasy or oil spots from being handled. I set up a line to suspend the bars and started the little and often undercoats to allow faster drying. The same for the satin black top coats to give a nice even coverage. The weather was sunny on and off, warm with a light breeze. Spraying from a rattle can in the breeze is all about timing and technique, the later from me being a little ‘rusty’ from not having done it for a a good few years.
The wife wasn’t to impressed with the new style grey and black patched grass I managed to create for her. The completed articles are mow ready to be taken back to Mustang Maniac for fitting and couple of other little bits at the same time where it would make things a lot easier with a car lift.
There are specific threaded bolts with a mid shoulder that are made specifically for the bars and will replace the originals when fitted.
Some may have an idea of what they are, if you know or think you know drop me comment. I hope to drive the car to Mustang Maniac next week sometime and I will obviously document what they are for then and bring you part two and a review. 👍