Hands On Or Off?

Last weekend I had the chance to use my new bit of detailing equipment. The particular item isn’t my first venture into this area of car detailing. I’m talking non-touch drying or air blow drying.

There are various methods to dry a car after a good wash and shampoo pampering;

Chamois leather, old school method.

Synthetic Chamois Leather, modern take on old school

Micro Fibre Towel, modern technology

Air Drying, dedicated air stream (hence non touch)

My new equipment is the Carbon Collective Air Force 1 Car Dryer Limited Edition (but only the colour) where I just completed a full in depth review. Carbon Collective are better known for their quality coatings and treatment products more than their accessories. This car drying unit of theirs is a cylinder design which is very similar principle to a follow along vacuum cleaner, but it blows air instead of sucking up dirt. The point of this unit is blow a filtered jet of air over the area to be dried. Not just a car, but anything that needs drying like; motorbike, cycle, household use, boat etc.

The forced air stream will dry the area without the need to touch the paint so it won’t cause any marks or swirls on the paint from the drying process itself, unlike a chamois or microfibre drying towel which could introduce swirls or marring. Not wanting to repeating myself too much (from the review here), there is a 5m mains cable, a generous reinforced 5m hose, adjustable air flow dial and an optional fan heated function. The base unit has lockable casters in each corner to stop or allow movement as required.

The nozzles are silicon tipped so any accidental contact with the surface being dried will not mark it. Each of the fittings has a bayonet style locking feature with a sealing ring to stop any unwanted air direction. With a maximum of seven cubic meters per minute being forced out through a small nozzle opening it needs to be securely held in place.

Perhaps the most important thing about this product is the filtration. Not one filter, but two, even though the accompanying book of words states one filter. If air is being sucked into the unit that low to the ground, then accelerated out with 900g of force, then any debris moved at that speed has the potential to be literally fired at the paint work. Think of hail stones, but on a much smaller scale. The removable filters are washable or cleaned with an air line.

Am I converted to this ‘non touch’ method? Well yes. Apart from the cost of running a 2800w motor and potentially a 600w heating element on top of that at the same time. The cost of running this for one hour (as this is published) will be approximately one British Pound per hour. Saying that when being caught out at a car show when it rains then the microfibre towel is still used of course.

I have lost count of the number of times I have gone to wax a car and found a water drip or a water spot left on the paint surface, it’s rather annoying at the best of times. This process does away with that as the air gets into the gaps and hidden areas where the water can sit. The down side is getting the equipment out, setting it up and putting it away again. Compared to taking a drying towel out the storage draws wipe over the car and put the towel in the washing basket when finished, there is more to it. But, the air drying is more thorough, providing you make it more thorough.

You will need to be careful with the air stream at the lower parts of the car not to blow loose debris around and potentially back on the car. Turning down the air force can be a real help under the wheel arches or on wheels etc. Once you master the technique is great. Probably not for the average weekend washer of the daily family car. But for a detailer this is a great addition to the detailing inventory. Not the cheapest of items, but I will get good use out of it.

I tried to film the process with hand on the phone and the other drying in the left hand video. The right hand video is just to show the force of the air from the wide opening nozzle blowing water around on the floor.

I do have another blower which is hand held MetroVac Air Force Blaster Sidekick SK1.

This is a 950w single hand held unit which has advantages and some disadvantages over the Air Force 1. I will get round to reviewing this bit of equipment very soon.

Nearly back to starting car shows again, and looking forward to that and getting some fresh air, well as much fresh air as you could get around classic car fumes! 😉