I worked a long day on the car over the weekend and I managed to complete a project that I wasn’t planning on. My original master cylinder produced a leak during the bleeding process. So to cut a long story short I upgraded to a Duel Master Cylinder System. Ok, my car is not concours original anymore, but I intend to drive and enjoy it not just show it, clean it and be unable to enjoy it because of the spec of dust on the exhaust. It has taken me most of the evening to write-up the process and pictures, but I am pleased with the results and wanted to share it as promised in my previous post. I have now posted the project under Photos – Engine bay – Dual Master Cylinder Upgrade, or click here for the quick link. This is no ordinary upgrade though, this kit includes a rear proportioning valve, built-in rear pressure valve and an inline pressure valve for the front brakes. Disc brake ready!
Next weekend I hope to bleed the brakes or at least try again.
The only side effect to my long day on the car was I felt like I had my legs run over by a bus. All that stretching and leaning over the fender took its toll on my hamstrings. Is it that I am getting old or should I have done some stretching exercises first? Yeah, like I wouldn’t look like a doughnut doing exercises in my garage to change a master cylinder! Us blokes don’t do that sort of thing, but I might just do that behind closed doors next time. 🙂
The recent bad weather has been doing wonders for the Rust test that I am still performing. The comparison is between the Granville Rust Cure and the FE-123. I will continue to run the experiment a while longer then I will post some pictures and results so far. I intend to do a long-term test and keep coming back to it with updates.